Preparation & Direction
Surfaces must be clean, dry and free from all surface contamination. Treat mould with bleach then rinse with fresh water. Fill in surface defects with suitable filler, putty or sealant.
Paper Faced Plasterboard, Fibre Cement, Masonry & Timber - First apply one coat of Tartan Classic Undercoat/Sealer
Apply two coats by roller or brush. Paint the corners and edges with a narrow brush and roll up to the edges. Stir paint in a circular motion for 5 minutes before use.
- Drying time: 30 minutes (touch dry)
- Recoat: 2 hours at 25C (allow 4 hours in cold or humid areas)
- Do not paint at temperatures below 10C
Avoid exposure to steam for 72 hours. Surface may be washed after 10 days but always avoid abrasive cleaners.
Up to 16m2 per litre. Coverage will be lower on rough or absorbent surfaces.
Ensure adequate ventilation, keep floors and furniture covered. Keep the lid on containers when not in use.
Please help us to protect our environment by following these disposal instructions:
Do not pour leftover paint down the drain. Unwanted paint should be brushed out on newspaper, allowed to dry and then disposed of via domestic waste collections. Empty paint containers should be left open in a well ventilated area to dry out. When dry, recycle steel or plastic containers via domestic recycling programs (may differ between local authorities. Check with your local council first).